How to do when the process of using thread insert jump buckle?

How to do when the process of using thread insert jump buckle ?

(1)Use a locking type thread insert installation spanner fitted ordinary type thread insert:In other matches with thread insert installation spanner.
(2)Exerted on the thread insert mounting shank axial force is too large:Axial force should not be imposed.
(3)Selection drill too large to shallow inner thread profile:Bottom scrapped,Changing the diameter of the drill with the appropriate.
(4)Taps badly worn caused internal thread profile shallow:With steel screw tap within the special plug gauge detection, if failure to pass then need replaced with new taps.
(5)Wire thread insert tooth-type half-width error is too large:Manufacturers exchange.
(6)Thread inserts diamond wire-surface severe ultra-poor:Manufacturers exchange.
(7)Thrust mounting shank excessive force when installed:Remove reinstall or switching to a mounting shank thread insert.